Effect of Infill Density in FDM 3D Printing on Low-Cycle Stress of Bamboo-Filled PLA-Based Material.

导出 OA

翻译打印收藏纠错

作者： Miroslav,Müller ^[1] ; Petr,Jirků ^[1] ; Vladimír,Šleger ^[2] ; Rajesh Kumar,Mishra ^[1] ; Monika,Hromasová ^[3] ; Jan,Novotný ^[4]

作者单位： Department of Material Science and Manufacturing Technology, Faculty of Engineering, Czech University of Life Sciences Prague, Kamycka 129, 165 00 Prague, Czech Republic. ^[1] Department of Mechanical Engineering, Faculty of Engineering, Czech University of Life Sciences Prague, Kamycka 129, 165 00 Prague, Czech Republic. ^[2] Department of Electrical Engineering and Automation, Faculty of Engineering, Czech University of Life Sciences Prague, Kamycka 129, 165 00 Prague, Czech Republic. ^[3] Faculty of Mechanical Engineering, J. E. Purkyne University in Usti nad Labem, Pasteurova 3334/7, 400 01 Usti nad Labem, Czech Republic. ^[4]

关键词 3D printing PLA polymer SEM bamboo infill density low-cycle test mechanical properties

DOI 10.3390/polym14224930

PMID 36433057

发布时间 2022-12-13

翻译满意度评价：

准确一般字义偏差语意偏离译文作用小提交