摘要Objective:To compare the biomechanical basis of 3 different internal fixation methods:nitinol patellar concentrator(NT-PC),tension band and wire circle in treating patellar fractures.Methods:The epoxy resin three dimensional photoelasticity patellar models were made by precise moulding,and were fixated by nitinol patellar concentrator(NT-PC),tension band and wire circle respectively.The patellar models with frozen stress stripes were put into the polarized light field and the stress distributions were compared.As for the model fixated by NT-PC,by dividing layer,photographing and tracing,we used the iterative method to calculate the stress value of every internal node of the epoxy resin patellar model,and the character of stress was analyzed.Results:An overall stress field was yielded when the patellar model was fixated by NT-PC,and the stripes were more than that of tension band model and wire circle model,which have only few stress stripes in the fixated layers.Further analysis indicated that there were continuous fixated stresses in the facies articularis and distal pole of patella,and the character of stresses produced by NT-PC were mainly in longitudinal direction,then in transverse direction.The shearing stresses were small.Conclusion:The initiative and continuous memorial stress of NT-PC and its overall stress distribution character are the essence of NT-PC distinguished with tension band and wire circle in treating patellar fractures.The stress character produced by NT-PC is good for the stability of fracture site and prompts fracture healing.